How often should a commercial ice machine be cleaned?

Every six months at minimum, and quarterly on hard Oklahoma water or in high-volume bars. Scale is the number one cause of low production and premature part failure.

My machine makes ice but only half as much as it used to.

Usually scale, a dirty condenser, high ambient temperature in the equipment room or a weakening sealed system. We measure production rate against the spec sheet to tell them apart.

Do you work on nugget and flake machines?

Yes — auger, gearbox, bearing and evaporator work on nugget and flaker machines as well as standard cubers.

Commercial Ice Machine Repair in Cushing, OK

An ice machine down in an Oklahoma summer means buying bagged ice by the pallet. We repair cubers, flakers and nugget machines — water systems, harvest cycles, sealed systems and controls — and deep-clean and sanitize the machine before we leave.

Call (405) 200-1490 Book Online

Commercial Ice Machine Service for Cushing Businesses

We handle commercial ice machine repair throughout Cushing and the rest of Payne County, including Cushing refinery district and downtown businesses. Most of our commercial work in Cushing is restaurants & bars, gas stations & c-stores, hotels & event venues — restaurants that need the line back before dinner, convenience stores with a cooler line to protect, and campus kitchens working around a class schedule.

Call (405) 200-1490 early in the day for the best chance at same-day commercial service in Cushing. Every visit ends with a written diagnosis and a firm price before any work starts.

Symptoms We See in Cushing

No ice production or a machine stuck in harvest
Thin, hollow or cloudy cubes
Bin thermostat or level sensor not shutting the machine off
Water leaking from the sump, curtain or drain
Scale, slime or pink mold in the water path
Error codes and repeated safety lockouts

What The Repair Covers

Full water-path descale and sanitize
Water inlet valve, float, pump and distributor repair
Harvest cycle, hot-gas valve and thermostat diagnostics
Sealed-system testing, leak repair and recharge
Control board, sensor and bin switch replacement
Water filter replacement and flow verification

Ice Machine Brands We Service in Cushing

Hoshizaki
Manitowoc
Scotsman
Ice-O-Matic
Follett
Cornelius
Kold-Draft

Questions From Cushing Operators

How often should a commercial ice machine be cleaned?: Every six months at minimum, and quarterly on hard Oklahoma water or in high-volume bars. Scale is the number one cause of low production and premature part failure.
My machine makes ice but only half as much as it used to.: Usually scale, a dirty condenser, high ambient temperature in the equipment room or a weakening sealed system. We measure production rate against the spec sheet to tell them apart.
Do you work on nugget and flake machines?: Yes — auger, gearbox, bearing and evaporator work on nugget and flaker machines as well as standard cubers.

Other Commercial Repairs in Cushing

Nearby Commercial Service Areas

All commercial repair in Cushing →More about commercial ice machine repair →Residential appliance repair in Cushing →